Comments on: 3D printed Dupont connector for jumper cable

By: Phil Hicks

Phil Hicks — Wed, 13 Nov 2024 11:49:34 +0000

These designs I am sure will help a baby boomer with little to no experience complete projects without the need for fragging components with very poor soldering techniques. I have one project in mind where I have nuked a PCB.
https://www.thingiverse.com/thing:4585839
Thank you also for making the model’s free.

By: Karel

Karel — Thu, 24 Oct 2024 08:48:26 +0000

I was lucky to find that page right at proper time for my projects.

Thank you VERY much.

By: Dupont connector (3D printing) ▷ 2024 - For screwing on!

Dupont connector (3D printing) ▷ 2024 - For screwing on! — Mon, 14 Oct 2024 09:18:28 +0000

[…] You may also be interested in: 3D printed Dupont connector for jumper cables […]

By: Conrad

Conrad — Mon, 13 May 2024 20:00:56 +0000

Really well done!
However, I’m printing on an Elegoo Neptune 4 Pro with PTEG and find the 4 pin connector is like .15mm too narrow for the 4 dupont ends to nest into the connector?? Any suggestions?
Thanks!

By: David Johns

David Johns — Wed, 13 Mar 2024 08:51:22 +0000

What a brilliant idea. I have a dexterity issue in my hands and fingers due to a neuropathy and inserting dupont wires is a bit of a nightmare. For single ones I normally use pair of snipe nose pliers to be able to grip them. These other designs for multiple wires will be an absolute saviour, thank you.

By: Joe Archambeault

Joe Archambeault — Thu, 22 Feb 2024 15:49:26 +0000

Would it be possible to get the files as STP rather than STL? Thanks

By: Mike

Mike — Fri, 16 Feb 2024 12:45:07 +0000

why is there a hole

By: James

James — Sat, 23 Dec 2023 03:25:24 +0000

Is the hole in the “lid” there for some purpose other than an orientation reminder?

Have you considered creating a set of connectors with orientation tabs to prevent plugging it in the wrong way? This would be especially useful on cable-to-cable connections but could also potentially be useful on a connector going to a board (assuming the connector was at the edge or some other place where a protrusion would stop it from going in the wrong way).

By: ts

ts — Mon, 20 Nov 2023 12:49:23 +0000

thanks. my students will enjoy this.

By: Benjamin Jordan

Benjamin Jordan — Wed, 25 Oct 2023 11:54:41 +0000

So I decided to just use the bottom piece and then use shrink tubbing to hold the pins in. Works great and looks good too! The shrink tube gives a smooth surface for writing with a sharpie. Thanks for the work you put into this!