Comments on: Upgrade: Data transfer via VLC and LiFi – Pi to Pi transfer

By: Shareef

Shareef — Fri, 11 Aug 2023 20:53:46 +0000

I am very grateful for your blog article, needed it for my thesis

By: Nerds

Nerds — Thu, 17 Mar 2022 21:09:40 +0000

In reply to J.

Yes, you also need to increase the file size on the receiver side 🙂

By: J

Tue, 15 Mar 2022 19:28:53 +0000

In reply to Nerds.

I managed to increase the file size for transmitting, but the receiver seems to be limited. It won’t go past 2kb of data. Is there a way to fix?

By: Nerds

Nerds — Sun, 06 Mar 2022 10:54:22 +0000

In reply to J.

Hey,

for testing purpose a set the file size to 2,5kB. But you can change it!

By: J

Fri, 25 Feb 2022 15:46:52 +0000

In reply to Nerds.

Hey. I was wondering what the limit file size was and if i could change it.

By: Nerds

Nerds — Sat, 22 Jan 2022 21:14:24 +0000

In reply to Sam.

Hey Sam,

the reason for this could be the distance of the laser. If the laser beam is too weak then it is hard for the solar panel to detect something. You can also try to change the solar panel.

By: Sam

Sam — Mon, 10 Jan 2022 02:05:19 +0000

I have setup the pi and software but while trying to send the data file from source pi to target pi, I do not see any activity.

By: Visible Light Communication (LiFi) ▷ Arduino and Raspberry Pi - 2021!

Visible Light Communication (LiFi) ▷ Arduino and Raspberry Pi - 2021! — Fri, 09 Jul 2021 07:36:15 +0000

[…] Previous Post Previous post: Cyclic Redundancy Check in C codeNext Post Next post: Upgrade: Data transfer via VLC and LiFi – Pi to Pi transfer […]